Instructions
Open the Assets page and click on the asset whose gateway you want to swap.
Go to the Data Sources tab.
Press the Swap data source button if it is visible.
If not, go to the Manually swap data source section of this guide.
Type the serial number of the new gateway in the With field, and then click Swap.
A new window will open where you can review the changes.
Click Confirm if the changes are correct.
Attention!
If the switch cannot be made 100% successfully, you will receive a notification. The data sources that can be successfully exchanged will be exchanged. For data sources where this is not possible, they must be entered manually. Refer to the Manually swap data source section of this article.
Manually swap data source
Attention!
The instructions in this chapter should only be executed if the Switch Data Source button is not available or if you prefer to make the adjustments to the data sources manually.
Press the pencil next to the name for a data source.
Click Add data source.
Tip!
If you hover over a data source with the mouse pointer (without clicking), the raw address appears in a black bar with the Slave ID at the end.
Activate the Use start date slider, and in the date field, to the right of the slider, enter the date when it's built-in.
Activate the Use end date slider, and in the date field, to the right of the slider, enter the date when it was replaced.
Press Save.