Instructions
Attention!
A USB expansion card for your Impulse gateway is required to complete this setup.
To connect the DEIF BGC-2 to the Impulse gateway, you need the following components:
DEIF programming interface Basic Genset Controller: RJ11 to RS232
StarTech ICUSB2322F: 1x USB to 2x RS232
StarTech SCNM9FF1MBK: RS232 female to RS232 female (zero-modem cable)
Hint!
If you want to connect two BGC-2s to one gateway, you will need two zero-modem cables.
Connect the DEIF BGC-2 to the programming interface via the RJ11 bus.
Connect the null modem cable to the programming interface.
Connect the null modem cable to the RS232 ←→ USB cable.
Connect the RS232 ←→ USB cable to the USB port of the Impulse gateway.
Optional: repeat the above steps with the second RS232 port to connect an additional DEIF BGC-2 to your gateway.