---
title: "Gateway swap C04 to C06"
slug: "gateway-swap-c04-to-c06"
updated: 2025-10-30T08:29:36Z
published: 2025-10-30T08:29:36Z
canonical: "docs.calculus.group/gateway-swap-c04-to-c06"
---

> ## Documentation Index
> Fetch the complete documentation index at: https://docs.calculus.group/llms.txt
> Use this file to discover all available pages before exploring further.

# Gateway swap C04 to C06

A guide to installing C06 gateways in DEIF AGC-200 controllers, or when you replace a C04 with a C06 and want to keep historical data.

## Register Gateway

### Modbus RTU

- **Gateway type**: Genset (AGC 200 over RS-485)
- **Slave ID:** 10
- **Baud rate**: 9600

### Modbus TCP/IP

- **Gateway type**: Genset (AGC 200 over ethernet)
- **Controller IP address**: 192.168.2.20
- **Slave ID:** 10

## Modify asset

Go to the current asset whose gateway you want to switch, and then to the **Data Sources** panel.

### The Switch databron button is visible

Press the **Switch Data Source** button. Enter the serial number of the new gateway (in the **With:** field) and press **Swap.** A new window will open where you can check the changes again. Click **Confirm** for the changes to take effect. If the conversion cannot be carried out 100% successfully, you will also receive a notification. The data sources where this has not been possible must be filled in manually (see the next section).

### Filling in data sources manually

Click the edit button of the data source. This is located to the right of the data source name and looks like a pencil. Click on the **Add data source** button at the bottom right of this screen. By hovering your mouse over a **data source** (do not click), the raw address appears in a black bar with the Slave ID at the end. When adding a new data source, you adjust the **Start date** to when the new gateway was built-in. Adjust the other data source (from the old gateway) as well, specify an end date here. This is the date when the gateway was replaced. After this, press **Save**.